|
R2D2Progress0001
This is the bottom section of Frame. It's based off Jerry's metal frame.
Date: 08/11/2006
Owner: Vincent Sanchez
Views: 3670
|
R2D2Progress0002
Complete wood frame. I used 1/2" dowels and 3/4" thick plywood.
Date: 08/11/2006
Owner: Vincent Sanchez
Views: 3077
|
R2D2Progress0003
A top view of the frame. Most every thing was just bolted together with standard wood screws. Attempting to stay within the SW universe, single slotted bolts were used.
Date: 08/11/2006
Owner: Vincent Sanchez
Views: 3109
|
|
R2D2Progress0004
Bottom view of the Fram. This is where the vacuum formed skirt will be attached.
Date: 08/11/2006
Owner: Vincent Sanchez
Views: 3311
|
R2D2Progress0005
Front view of the body with the laser etched aluminum skins. It was easier to work with out the skirt section attached, so it was temporarily removed.
Date: 08/11/2006
Owner: Vincent Sanchez
Views: 3159
|
R2D2Progress0006
Back view of the body with John's skins. The skins were attached with just 4 wood screws. This helped to judge where all the different components needed to go before securing the skins completely.
Date: 08/11/2006
Owner: Vincent Sanchez
Views: 3244
|
|
R2D2Progress0007
Top view of the body with aluminum skins. This is where most all the electronics will go.
Date: 08/11/2006
Owner: Vincent Sanchez
Views: 2966
|
R2D2Progress0008
Work had just begin on the R5D4 dome for C3, so this was just a test "fitting". Also notice that panels have been removed and the skins cleaned up.
Date: 08/11/2006
Owner: Vincent Sanchez
Views: 3117
|
R2D2Progress0009
The legs with feet were attached with carriage bolts. Since the electronics would have to be installed after C3, the 2 legged pose was necessary.
Date: 08/11/2006
Owner: Vincent Sanchez
Views: 3045
|
